Windshield Intermittent Wiper Inspection

2017 Mitsubishi Mirage G4 ES, Automatic CVT TransSECTION Windshield Intermittent Wiper Inspection
  1. Check that the intermittent wiper interval is changed as the windshield intermittent wiper volume is operated.
  2. Turn the windshield intermittent wiper switch to the intermittent operation position. Use the M.U.T.-III to set a simulated vehicle speed with the wiper volume held. The intermittent wiper interval should be changed as the simulated vehicle speed is changed.
  3. If either of above is defective, carry out the troubleshooting (Refer to INSPECTION PROCEDURE 5: THE WINDSHIELD INTERMITTENT WIPER INTERVAL CANNOT BE ADJUSTED BY OPERATING THE WINDSHIELD INTERMITTENT WIPER VOLUME CONTROLΒ ).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.