Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2017MIRAGE G4 ES, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESETACS
2017 Mitsubishi Mirage G4 ES, Automatic CVT Trans
Communication Devices: ETACS
2017 Mitsubishi Mirage G4 ES, Automatic CVT TransSECTION ETACS
- Special Tools
- Diagnosis
- Diagnostic Trouble Code Chart
- Diagnostic Trouble Code Procedures
- DTC B1709: ETACS Ecu (EEPROM)
- DTC B1760: Coding not completed
- DTC B1761: VIN not programmed
- DTC B1762: IOD fuse not seated fully; DTC B1765: ECU fuse
- DTC B2206: VIN error/Mismatch
- DTC U1000: OSS/F.A.S.T._OSS CAN timeout
- DTC U1100: Engine CAN timeout
- DTC U1101: T/M CAN timeout/Not equipped
- DTC U1102: ASC/TCL/ABS timeout/Not equipped
- DTC U1108: Meter CAN timeout/Not equipped
- DTC U1110: A/C CAN timeout/Not equipped
- DTC U1116: F.A.S.T. CAN timeout/No equipped
- DTC U1150: Fail Info. for vehicle speed
- Service Data Inspection Procedure
- Check Chart For Trouble Symptoms
- Symptom Procedures
- Check Trouble By Using The Input Signal Check
- Input Signal Procedures
- Inspection Procedure 1: The ignition switch (ACC) signal is not received
- Inspection Procedure 2: The ignition switch (IG1) signal is not received
- Inspection Procedure 3: The key reminder switch signal is not received
- Inspection Procedure 4: The front door lock actuator (driver's side) signal is not received
- Inspection Procedure 5: The front door switch (driver's side) signal is not received
- Inspection Procedure 6: The front door switch (passenger's side) signal is not received
- Inspection procedure 7: One of the door switch signals is not received
- Inspection Procedure 8: The hazard warning light switch signal is not received
- Inspection Procedure 9: The column switch signal is not received
- Inspection Procedure 10: The stoplight switch signal is not received
- Inspection Procedure 11: The rear window defogger switch signal is not received.
- Inspection Procedure 12: The rear window defogger switch signal is not received.
- Inspection Procedure 13: The backup light switch signal is not received.
- Check At Ecu Terminal
- On-Vehicle Service
- ETACS-Ecu
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.