Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2012RVR ESREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSKEYLESS OPERATION SYSTEM (KOS)ON-VEHICLE SERVICE (KOS-ECU)KEYLESS ENTRY SYSTEM CHECK
2012 Mitsubishi RVR ES
Keyless Entry System Check
2012 Mitsubishi RVR ESSECTION Keyless Entry System Check
Check the keyless entry system as described below. If it does not work, perform troubleshooting (Refer to ACTUATOR TEST TABLE .
- Operate the keyless operation key to check that the doors and the liftgate can be locked and unlocked.
- Operate the keyless operation key to check that the answerback function works in response to door and liftgate locking/unlocking.NOTE: The hazard answerback setting can be changed using the customization function. Confirm which setting is activated before performing these checks (Refer to CUSTOMIZATION FUNCTION .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.