Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2012OUTLANDER AWD L4-2.4L (4B12)REPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSTESTING AND INSPECTIONCOMPONENT TESTS AND GENERAL DIAGNOSTICSPOWER WINDOW OPERATING CURRENT CHECK
2012 Mitsubishi Outlander AWD L4-2.4L (4B12)
Power Window Operating Current Check
2012 Mitsubishi Outlander AWD L4-2.4L (4B12)SECTION Power Window Operating Current Check
POWER WINDOW OPERATING CURRENT CHECK
1. Remove the power window fuse to check that it is normal, and connect a multimeter as shown in the illustration.
2. Raise the power window to measure the current during operation.
Standard value: 7 ± 1 A [Power supply voltage 14.5 ± 0.5 V, at 25°C (77°F)]
NOTE:
If the power supply voltage does not meet the standard value, check and repair the generator and the battery. Then carry out this check again.
3. If the operation current is outside the standard value, refer to Initial Inspection and Diagnostic Overview.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.