Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMITSUBISHI2012OUTLANDER 2WD V6-3.0L (6B31)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTESTING AND INSPECTIONSCAN TOOL TESTING AND PROCEDURESDATA LIST REFERENCE TABLE

2012 Mitsubishi Outlander 2WD V6-3.0L (6B31)

Data List Reference Table

2012 Mitsubishi Outlander 2WD V6-3.0L (6B31)SECTION Data List Reference Table

DATA LIST REFERENCE TABLE

CAUTION:

- When shifting the selector lever to D range, the brakes should be applied so that the vehicle does not move forward.

- Driving tests always need two persons: one driver and one observer.

NOTE:
*1: In a new vehicle [driven approximately 500 km (311 mile) or less], the mass airflow sensor output value is sometimes 10% higher than the standard value.

NOTE:
*2: The injector drive time represents the time when the cranking speed is at 250 r/min or below when the power supply voltage is 11 volts.

NOTE:
*3: In a new vehicle [driven approximately 500 km (311 mile) or less], the injector drive time is sometimes 10% longer than the standard time.

NOTE:
*4: Vehicles for Canada, the headlight, taillight, etc. remain lit even when the lighting switch is in "OFF" position but this is no problem for checks.