Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2012OUTLANDER 2WD V6-3.0L (6B31)REPAIR AND DIAGNOSISBODY AND FRAMELOCKSKEYLESS ENTRYTESTING AND INSPECTIONCOMPONENT TESTS AND GENERAL DIAGNOSTICSWIRELESS CONTROL MODULE (WCM)KEYLESS ENTRY SYSTEM INSPECTION
2012 Mitsubishi Outlander 2WD V6-3.0L (6B31)
Keyless Entry System Inspection
2012 Mitsubishi Outlander 2WD V6-3.0L (6B31)SECTION Keyless Entry System Inspection
KEYLESS ENTRY SYSTEM CHECK
Check the keyless entry system function as described below. If it does not work, perform troubleshooting. Refer to Symptom Chart.
- Operate the transmitter to check that the doors and liftgate can be locked and unlocked.
- Operate the transmitter to check that the answer back function works in response to door and liftgate locking/unlocking.
NOTE:
The hazard and horn answer back setting can be changed using the customization function. Confirm which setting is activated before performing these checks. Refer to Configuration Function.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.