Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2012LANCER RALLIARTREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESPARKING BRAKE SYSTEMPARKING BRAKES - LANCERSERVICE SPECIFICATIONS
2012 Mitsubishi Lancer Ralliart
Service Specifications
2012 Mitsubishi Lancer RalliartSECTION Service Specifications
PARKING BRAKE SPECIFICATIONS
| Item | Standard value | Limit | |
|---|---|---|---|
| Parking brake lever stroke [Control force approximately 200 N (45 pounds)] | 3 to 5 notches | - | |
| Brake lining thickness < Vehicles with rear disk brake > mm (in) | 2.8 (0.11) | 1.0 (0.04) | |
| Brake drum inside diameter < Vehicles with rear disk brake > mm (in) |
Except RALLIART | 168.0 (6.61) | 169.0 (6.65) |
| RALLIART | 190.0 (7.48) | 191.0 (7.52) | |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.