SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2012LANCER RALLIARTREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEWINDOWSWINDOW GLASS - LANCERWINDSHIELDREMOVAL AND INSTALLATIONINSTALLATION SERVICE POINTS>> A << WINDSHIELD SPACER/GLASS STOPPER/WINDSHIELD UPPER MOLDING/WINDSHIELD SIDE MOLDING INSTALLATION
2012 Mitsubishi Lancer Ralliart

&gt;&gt; A &lt;&lt; Windshield Spacer/Glass Stopper/Windshield Upper Molding/Windshield Side Molding Installation

2012 Mitsubishi Lancer RalliartSECTION >> A << Windshield Spacer/Glass Stopper/Windshield Upper Molding/Windshield Side Molding Installation
CAUTION: Leave the degreased parts for 3 or more minutes to dry well, before starting on the next step. Do not touch the degreased parts.
  1. Use 3M™ AAD Part number 8906 or equivalent to degrease the inside and outside of the windshield glass and the body flanges.
    Fig 1: Identifying Windshield Spacer And Glass Stopper Installation Position
    G08294357Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Install the windshield spacer and glass stoppers to the specified positions so that there are no adrift or warped surfaces inside the windshield glass.
    Fig 2: Identifying Adhesive Tape Installation Position
    G08294358Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  3. Install the adhesive tape (double-sided tape) to the windshield glass.
  4. Install the windshield molding and front deck garnish retainer to the windshield glass.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.