Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2012LANCER EVOLUTION GSRREPAIR AND DIAGNOSISENGINE MECHANICALMECHANICALENGINE MECHANICAL - LANCER EVOLUTIONCYLINDER HEAD GASKETREMOVAL AND INSTALLATIONINSTALLATION SERVICE POINTS>>G<< FUEL HIGH-PRESSURE HOSE CONNECTION
2012 Mitsubishi Lancer Evolution GSR
>>G<< Fuel High-Pressure Hose Connection
2012 Mitsubishi Lancer Evolution GSRSECTION >>G<< Fuel High-Pressure Hose Connection
CAUTION:
- When pushing in the retainer of the fuel high-pressure hose connector, pay attention to avoid damage to the retainer.
- After the installation of the fuel high-pressure hose, slightly pull the fuel high-pressure hose to check that it is connected securely. At this time, also check that there is approximately 1 mm (0.04 inch) play.
- Securely insert the fuel rail stopper into the fuel high-pressure hose connector groove to install the fuel high-pressure hose to the fuel rail.
- Push in the retainer of the fuel high-pressure hose connector to lock the fuel high-pressure hose and fuel rail.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.