Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2007OUTLANDER LS, FWDREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSDIAGNOSIS & ON-VEHICLE TESTINGTRANSAXLE CONTROLREMOVAL AND INSTALLATIONINSTALLATION SERVICE POINTSA << TRANSAXLE CONTROL CABLE (TRANSAXLE SIDE) INSTALLATION
2007 Mitsubishi Outlander LS, FWD
A << Transaxle Control Cable (Transaxle Side) Installation
2007 Mitsubishi Outlander LS, FWDSECTION A << Transaxle Control Cable (Transaxle Side) Installation
- Move the selector lever and manual control lever to the N position.
- Use the adjusting nut to tighten the transaxle control cable to the specified torque.
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Tightening torque: 9.5 ± 3.5 N.m (84 ± 31 in-lb)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.