Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMITSUBISHI2007OUTLANDER LS, FWDREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSDIAGNOSIS & ON-VEHICLE TESTINGON-VEHICLE SERVICEESSENTIAL SERVICETRANSMISSION RANGE SWITCH CHECK

2007 Mitsubishi Outlander LS, FWD

Transmission Range Switch Check

2007 Mitsubishi Outlander LS, FWDSECTION Transmission Range Switch Check

Fig 1: Identifying Transaxle Control Cable And Manual Control Lever Adjusting Nut

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

TRANSMISSION RANGE AND TERMINALS CONNECTION

Transmission on range	Terminal connection of tester	Specified condition
P	3-2,7-10	Less than 2 ohms.
R	3-9
N	3-8,7-10
D	3-5

Fig 2: Identifying Transmission Range

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.