Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2007OUTLANDER LS, FWDREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSDIAGNOSIS & ON-VEHICLE TESTINGAUTOMATIC TRANSAXLE DIAGNOSISDIAGNOSTIC TROUBLE CODE PROCEDURESDTC P0712: TRANSMISSION FLUID TEMPERATURE SENSOR SYSTEM (SHORT CIRCUIT)DTC SET CONDITIONS
2007 Mitsubishi Outlander LS, FWD
DTC Set Conditions
2007 Mitsubishi Outlander LS, FWDSECTION DTC Set Conditions
Check Conditions
- Vehicle speed: more than 10 km/h (6.2 mph).
- Transmission range switch position: D.
- Throttle opening: more than 1/8.
- Engine speed: more than 305 r/min.
Judgement Criteria
- Value of temperature of transmission fluid: more than 180°C (356°F). (10 minutes)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.