General Maintenance Service For Proper Vehicle Performance

2007 Mitsubishi Outlander LS, FWDSECTION General Maintenance Service For Proper Vehicle Performance
GENERAL MAINTENANCE SERVICE FOR PROPER VEHICLE PERFORMANCE

No. General maintenance Service intervals Kilometers in thousands 24 48 72 96 120 144 168 192
Mileage in thousands 15 30 45 60 75 90 105 120
Months 12 24 36 48 60 72 84 96
10 Engine oil Change Every 6 months or every 12,000 km (7,500 miles)
11 Engine oil filter Replace Every 6 months or every 12,000 km (7,500 miles)
13 Transfer oil Check oil level and condition   X   X   X   X
Change       X       X
14 Engine coolant Change       X at first   X   X
15 Coolant hoses (radiator hose, heater hose) Inspect   X   X   X   X
16 Disc brake pads, rotors Inspect for wear Every 12 months or every 24,000 km (15,000 miles)
17 Brake hoses Check for deterioration or leaks Every 12 months or every 24,000 km (15,000 miles)
18 Ball joint and steering linkage seals Inspect for grease leaks and damage   X   X   X   X
19 Drive shaft boots Inspect for grease leaks and damage Every 12 months or every 24,000 km (15,000 miles)
20 Suspension system Inspect for looseness and damage   X   X   X   X
21 Rear axle oil Check oil level   X   X   X   X
22 Tires Rotate Every 12,000 km (7,500 miles)
23 Air filter Replace Every 18 months or every 24,000 km (15,000 miles)
NOTE: *: This maintenance is recommended but is not required to maintain the emissions warranty.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.