Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2007OUTLANDER LS, FWDREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLANTI-LOCK BRAKING SYSTEM (ABS)WHEEL SPEED SENSORREMOVAL AND INSTALLATIONNOTES
2007 Mitsubishi Outlander LS, FWD
Removal And Installation: Notes
2007 Mitsubishi Outlander LS, FWDSECTION Notes
CAUTION:
The vehicle speed detection encoder collects any metallic particle easily, because it is magnetized. Make sure that the encoder should not collect any metallic particle. Check that there is not any trouble prior to reassembling it.
Pre-removal and post-installation operation
- Air cleaner body assembly removal and installation (Refer to AIR CLEANER .) Front wheel speed sensor (LH)
- Quarter trim removal and installation (Refer to TRIM .) Rear wheel speed sensor
NOTE:
The vehicle speed detection encoder is integrated with the front wheel bearing and the rear hub assembly, which cannot be disassembled.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.