Symptom Chart

2007 Mitsubishi Outlander LS, FWDSECTION Symptom Chart
NOTE: For additional Symptom Chart information, refer to TSB UPDATED CRUISE CONTROL DIAGNOSIS - SERVICE MANUAL REVISION .
SYMPTOM CHART

Symptom Inspection procedure number
Scan tool communication with ECM Is not possible. GROUP 13Ab, Symptom Procedures - Inspection Procedure 1 P.13Ab-753.
Auto-cruise control system is not cancelled. When brake pedal is depressed 1Β 
When selector lever is moved to "N" position 2Β 
When "CANCEL" switch is turned ON 3Β 
Auto-cruise control system cannot be set. 4Β 
Hunting (repeated acceleration and deceleration) occurs at the set vehicle speed. 5Β 
When "ON/OFF" switch is turned "ON", "CRUISE" indicator light inside combination meter does not illuminate. (However, autocruise control system is normal). 6Β 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.