SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2007OUTLANDER LS, FWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALBODY ELECTRICALCHASSIS ELECTRICALCOMBINATION METERDIAGNOSISDIAGNOSTIC TROUBLE CODE PROCEDURESDTC U0245: AUDIO VISUAL NAVIGATION UNIT CAN TIMEOUTDIAGNOSIS
2007 Mitsubishi Outlander LS, FWD

DTC U0245: Audio visual navigation unit CAN timeout: Diagnosis

2007 Mitsubishi Outlander LS, FWDSECTION Diagnosis

Required Special Tools:

  • MB991958: Scan Tool (M.U.T.-III Sub Assembly)
    • MB991824: Vehicles Communication Interface (V.C.I.)
    • MB991827: M.U.T.-III USB Cable
    • MB991910: M.U.T.-III Main Harness A (Vehicles with CAN communication system)
  1. STEP 1. Using scan tool MB991958, diagnose the CAN bus line. 
    CAUTION: To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991958.
    1. Connect scan tool MB991958. Refer to "HOW TO CONNECT THE SCAN TOOL (M.U.T.-III)  ."
    2. Turn the ignition switch to the "ON" position.
    3. Diagnose the CAN bus line.
    4. Turn the ignition switch to the "LOCK" (OFF) position.

    Q: Is the CAN bus line found to be normal? 

    YES:  Go to Step 2.

    NO:  Repair the CAN bus line. (Refer to DIAGNOSIS ).

    Fig 1: Connecting Scan Tool To Data Link Connector
    G04873988Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. STEP 2. Using scan tool MB991958, read the audio visual navigation unit diagnostic trouble code. 

    Check if DTC is set to the audio visual navigation unit.

    Q: Is the DTC set? 

    YES:  Troubleshoot the MMCS. Refer to AUDIO AND NAVIGATION SYSTEM .

    NO:  Go to Step 3.

  3. STEP 3. Recheck for diagnostic trouble code. 

    Check again if the DTC is set to the combination meter.

    1. Erase the DTC.
    2. Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
    3. Check if DTC is set.
    4. Turn the ignition switch to the "LOCK" (OFF) position.

    Q: Is the DTC set? 

    YES:  Replace the combination meter.

    NO:  The trouble can be an intermittent malfunction (Refer to HOW TO COPE WITH INTERMITTENT MALFUNCTION ).

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.