Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Speed-Increase Setting
2007 Mitsubishi Outlander LS, FWDSECTION Speed-Increase Setting
- Switch the "ON/OFF" switch to "ON".
- Set to the desired speed, above approximately 40 km/h (25 mph).
- Push the "ACC/ES" switch.
- Check to be sure that acceleration continues while the "ACC/RES" switch is pushed, and that the speed at the time it was released becomes the constant driving speed.NOTE: Acceleration can be continued even if the vehicle speed has passed the high-speed limit [approximately 160 km/h (100 mph)]. But the constant driving speed when the "ACC/RES" switch is released will be recorded as the high-speed limit.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.