Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Mitsubishi Lancer AutomaticFACTORY OEM SERVICE PROCEDURE
Automatic Trans: Overhaul
- General Information
- Special Tools
- Transaxle
- Oil Pump
- UNDERDRIVE Clutch And Input Shaft
- Reverse And Overdrive Clutch
- Planetary Gear
- Low-Reverse Brake
- Second Brake
- Output Shaft
- Differential
- Valve Body
- Drive Shaft Oil Seal
- Specifications
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
