Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2007ENDEAVOR SE, FWDREPAIR AND DIAGNOSISSUSPENSIONWHEELS & TIRE SYSTEMWHEEL AND TIRETIRE PRESSURE MONITORING SYSTEM (TPMS) DIAGNOSISCHECK AT TPMS RECEIVERTPMS RECEIVER GROUND CHECK
2007 Mitsubishi Endeavor SE, FWD
TPMS Receiver Ground Check
2007 Mitsubishi Endeavor SE, FWDSECTION TPMS Receiver Ground Check
- Turn the ignition switch to the "LOCK" (OFF) position and disconnect the TPMS receiver connector.
- Check the resistance and continuity between terminal 6 of the harness connector and body ground. The resistance should measure less than 2 ohms.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.