Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2007ENDEAVOR SE, FWDREPAIR AND DIAGNOSISGENERAL INFORMATIONOBD-II DRIVE CYCLESDRIVE CYCLE PROCEDURES2007-09 RAIDEREGR MONITOR
2007 Mitsubishi Endeavor SE, FWD
EGR Monitor
2007 Mitsubishi Endeavor SE, FWDSECTION EGR Monitor
After the vehicle has reach the below conditions and during a throttle decel the EGR monitor will run.
- Engine RPM between 1375 - 2500
- Engine temperature greater than 70°C (158°F)
- Engine run time greater than 125 seconds
- Vehicle speed between 25 - 70 mph
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.