Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2007ENDEAVOR SE, FWDREPAIR AND DIAGNOSISGENERAL INFORMATIONOBD-II DRIVE CYCLESDRIVE CYCLE PROCEDURES2007 GALANT 2.4L, OUTLANDERPATTERN 16TEST PROCEDURE
2007 Mitsubishi Endeavor SE, FWD
Test Procedure
2007 Mitsubishi Endeavor SE, FWDSECTION Test Procedure
- Start the engine with all the accessories switched OFF.
- Accelerate until the vehicle speed is more than 50 km/h (31 mph).
- Engine speed: More than 2,500 r/min
- Engine load: More than 55%
- Stop at safe place and let the engine idle for 20 seconds. (During the monitor)
- Repeat Steps 2 and 3 for 10 times.
- Stop the vehicle at the safe place and turn the ignition switch to "LOCK" (OFF) position.
Start the engine and do Steps 1 to 5 again. Confirm that the diagnostic trouble code (DTC) is not output.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.