Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2007ENDEAVOR SE, FWDREPAIR AND DIAGNOSISENGINE PERFORMANCEFUEL DELIVERYFUEL SUPPLYON-VEHICLE SERVICEFUEL PUMP MODULE REPLACEMENT
2007 Mitsubishi Endeavor SE, FWD
Fuel Pump Module Replacement
2007 Mitsubishi Endeavor SE, FWDSECTION Fuel Pump Module Replacement
- Remove the left rear seat cushion mounting bolts, and lift the left rear seat cushion and tie it to the head restraint.
- Cut the floor mat and then remove the service hole cover to gain access to the service hole.NOTE: Push the floor mat to find the notches and cut the floor mat along them.
- Fuel Pump Connector Disconnection (How to Reduce Fuel Pressure). (Refer to ON-VEHICLE SERVICE ).
- Disconnect the fuel pump module connector, the fuel tank differential pressure sensor connector and fuel high-pressure hose.
- Remove the mounting nuts and plate, and remove the fuel pump module from the fuel tank.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.