Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMITSUBISHI2007ENDEAVOR SE, FWDREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSBODYWINDOW GLASSINSPECTIONGLASS HATCH HANDLE CHECK

2007 Mitsubishi Endeavor SE, FWD

Glass Hatch Handle Check

2007 Mitsubishi Endeavor SE, FWDSECTION Glass Hatch Handle Check

Then check continuity between the glass hatch handle terminals.

TESTING GLASS HATCH HANDLE

HANDLE POSITION	TESTER CONNECTION	SPECIFIED CONDITION
At the "ON" position	1 - 2	Less than 2 ohms
At the "OFF" position	1 - 2	Open circuit

Fig 1: Identifying Glass Hatch Handle Connector Terminal

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.