SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2007ENDEAVOR SE, FWDREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSBODYWINDOW GLASSINSPECTIONCONTACT CONNECTOR (LIFTGATE SIDE) CHECK
2007 Mitsubishi Endeavor SE, FWD

Contact Connector (Liftgate Side) Check

2007 Mitsubishi Endeavor SE, FWDSECTION Contact Connector (Liftgate Side) Check

Check that there is continuity between the electrical contact of the contact connector (liftgate side) and the connector terminal.

TESTING CONTACT CONNECTOR (LIFTGATE SIDE)

TESTER CONNECTION SPECIFIED CONDITION
Between electrical contact 1 of the contact connector and connector F-13 terminal 5 Less than 2 ohms
Between electrical contact 2 of the contact connector and connector F-13 terminal 3 Less than 2 ohms
Between electrical contact 3 of the contact connector and connector F-13 terminal 1 Less than 2 ohms
Between electrical contact 4 of the contact connector and connector F-13 terminal 4 Less than 2 ohms
Between electrical contact 5 of the contact connector and connector F-13 terminal 2 Less than 2 ohms
Fig 1: Identifying Contact Connector - Liftgate Side
G04312692Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.