Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2007ENDEAVOR SE, FWDREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSBODYWINDOW GLASSINSPECTIONCONTACT CONNECTOR (GLASS HATCH SIDE) CHECK
2007 Mitsubishi Endeavor SE, FWD
Contact Connector (Glass Hatch Side) Check
2007 Mitsubishi Endeavor SE, FWDSECTION Contact Connector (Glass Hatch Side) Check
Press and hold the electrical contact of the contact connector (glass hatch side). Check that there is continuity between the electrical contact and the connector terminal.
TESTING CONTACT CONNECTOR (GLASS HATCH SIDE)
| TESTER CONNECTION | SPECIFIED CONDITION |
|---|---|
| Between electrical contact 1 of the contact connector and connector F-16 terminal 2 | Less than 2 ohms |
| Between electrical contact 2 of the contact connector and connector F-16 terminal 1 | Less than 2 ohms |
| Between electrical contact 2 of the contact connector and connector F-07 terminal 2 | Less than 2 ohms |
| Between electrical contact 3 of the contact connector and connector F-07 terminal 1 | Less than 2 ohms |
| Between electrical contact 4 of the contact connector and connector F-16 terminal 4 | Less than 2 ohms |
| Between electrical contact 5 of the contact connector and connector F-16 terminal 3 | Less than 2 ohms |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.