SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2007ENDEAVOR SE, FWDREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSBODYSUNROOF ASSEMBLYON-VEHICLE SERVICESUNROOF INITIALIZATION
2007 Mitsubishi Endeavor SE, FWD

Sunroof Initialization

2007 Mitsubishi Endeavor SE, FWDSECTION Sunroof Initialization

The sunroof should be initialized when any of the following components are replaced, the sunroof position is miss timed, the sunroof is in learn mode.

  • Roof lid glass assembly
  • Sunroof motor
  • Sunroof-ECU
  1. Ensure the components are correctly assembled. Ensure all the connectors are connected securely.
  2. If the sunroof is already in learn mode, go to step 3. If the sunroof is not in learn mode, enter learn mode by i or ii.
    1. Disconnect the sunroof-ECU connector while the sunroof is operating.
    2. Activate the jam preventing mechanism five times continuously.
  3. Press the sunroof Close switch repeatedly until the sunroof is tilted up fully.
  4. Press and hold the sunroof Close switch for at least three seconds.
  5. Press the sunroof Close switch until the sunroof closes fully.
  6. Press the sunroof Open switch until the sunroof opens fully. Then press the sunroof Close switch until the sunroof closes fully. The sunroof should work normally.
    NOTE: Do not stop the sunroof before it reaches the fully open or fully closed position during operations in steps  5 and  6 above. If the sunroof has stopped accidentally, repeat the procedure from step  1.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.