SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2007ENDEAVOR SE, FWDREPAIR AND DIAGNOSIS (SINGLE PAGE)GENERAL INFORMATIONOBD-II DRIVE CYCLESDRIVE CYCLE PROCEDURES2011-12 OUTLANTER 3.0LPATTERN 3TEST PROCEDURE
2007 Mitsubishi Endeavor SE, FWD

Test Procedure

2007 Mitsubishi Endeavor SE, FWDSECTION Test Procedure
  1. Start the engine with all the accessories switched OFF.
  2. Accelerate until the vehicle speed is 60 km/h (38 mph) and then drive the vehicle for 90 seconds.
  3. Release the accelerator pedal and reduce vehicle speed to 30 km/h (18 mph). (During the monitor)
  4. Accelerate until the vehicle speed is 60 km/h (38 mph) and then drive the vehicle for 20 seconds.
  5. Release the accelerator pedal and reduce vehicle speed to 30 km/h (18 mph). (During the monitor)
  6. Stop the safe place and turn the ignition switch to "LOCK" (OFF) position.
  7. Start the engine and do Steps 1 to 6 again. When the vehicle is operating normally and the OBD-II Drive Cycle is carried out, the Readiness Codes will be set as "Complete" on the first drive cycle. The second drive cycle is required to set the Readiness Codes as "Complete" if a fault is detected during the first drive cycle.
  8. Confirm that the diagnostic trouble code (DTC) is not output.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.