Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2007ENDEAVOR SE, FWDREPAIR AND DIAGNOSIS (SINGLE PAGE)GENERAL INFORMATIONOBD-II DRIVE CYCLESDRIVE CYCLE PROCEDURES2011-12 LANCER 2.0L TURBOPATTERN 2TEST PROCEDURE
2007 Mitsubishi Endeavor SE, FWD
Test Procedure
2007 Mitsubishi Endeavor SE, FWDSECTION Test Procedure
- Start the engine with all the accessories switched OFF.
- Let the engine idle for 2 minutes. (During the monitor)
- Turn the ignition switch to the "LOCK" (OFF) position.
- Start the engine and do Steps 1 to 3 again. When the vehicle is operating normally and the OBD-II Drive Cycle is carried out, the Readiness Codes will be set as "Complete" on the first drive cycle. The second drive cycle is required to set the Readiness Codes as "Complete" if a fault is detected during the first drive cycle.
- Confirm that the diagnostic trouble code (DTC) is not output.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.