Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2007ENDEAVOR SE, FWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALMOTORS, SWITCHES, RELAYSGENERAL (ELECTRICAL)HARNESS CONNECTOR INSPECTIONCOMPUTER CONNECTOR
2007 Mitsubishi Endeavor SE, FWD
Computer Connector
2007 Mitsubishi Endeavor SE, FWDSECTION Computer Connector
- Insert a screwdriver [1.4 mm (0.06 inch) width] as shown in the illustration, disengage the front holder, and remove it.
- Push the harness wire of the terminal to be repaired deep into the connector from the harness side and hold it there.
- Insert the tip of the screwdriver [1.4 mm (0.06 inch) width] into the connector as shown in the illustration, gently push the housing lance down with the tip, and pull out the terminal.
- Insert a needle through the hole provided on the terminal and raise the contact point. Lightly squeeze the outer edge so the flats are parallel with the bottom.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.