Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2007ENDEAVOR SE, FWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALHORNSCHASSIS ELECTRICALMULTI-CENTER DISPLAYMULTI-CENTER DISPLAY DIAGNOSTIC TROUBLE CODE DIAGNOSISDIAGNOSISSYMPTOM CHART
2007 Mitsubishi Endeavor SE, FWD
Symptom Chart
2007 Mitsubishi Endeavor SE, FWDSECTION Symptom Chart
CAUTION:
During diagnosis, a DTC associated with other system may be set when the ignition switch is turned on with connector(s) disconnected. On completion, confirm all systems for DTC (s). If DTC (s) are set, erase them all.
SYMPTOM CHART
| SYMPTOM | INSPECTION PROCEDURE |
|---|---|
| Communication with scan tool is not possible. (Middle Grade Type) | 1 |
| The multi-center display does not show any information. (Middle Grade Type) | 2 |
| The multi-center display does not show any information. (Low Grade Type) | 3 |
| The A/C display shows "COMMUNICATION ERROR", and then can not proceed to next screen. (Middle Grade Type) | 4 |
| The ambient air temperature display shows "COM ERROR" or "--deg°C (--°F). (Middle Grade Type) | 5 |
| On the audio screen, "COMMUNICATION ERROR" can not proceed to next screen. (Middle Grade Type) | 6 |
| The compass can not be calibrated manually, or become out of calibration easily. (Middle Grade Type) | 7 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.