Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2007ENDEAVOR SE, FWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALCOMPONENT LOCATIONSELECTRICAL COMPONENT LOCATORBUZZERS, RELAYS & TIMERS
2007 Mitsubishi Endeavor SE, FWD
Buzzers, Relays & Timers
2007 Mitsubishi Endeavor SE, FWDSECTION Buzzers, Relays & Timers
BUZZERS, RELAYS & TIMERS LOCATION
| Component | Location |
|---|---|
| A/C Compressor Clutch Relay | On engine compartment relay box. See Figure. |
| A/T Control Relay | On engine compartment relay box. See Figure. |
| Defogger Relay | On junction block. See Figure. |
| Fan Control Relay | On engine compartment relay box. See Figure. |
| Fog Light Relay | On engine compartment relay box. See Figure. |
| Front Blower Relay | On junction block. See Figure. |
| Fuel Pump Relay (1) | On junction block. See Figure. |
| Fuel Pump Relay (2) | On junction block. See Figure. |
| Heated Seat Relay | On junction block. See Figure. |
| Horn Relay | On engine compartment relay box. See Figure. |
| MFI Relay | On engine compartment relay box. See Figure. |
| Power Window Relay | On junction block. See Figure. |
| Rear Blower Relay | On junction block. See Figure. |
| Throttle Actuator Control Motor Relay | On engine compartment relay box. See Figure. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.