Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2007ENDEAVOR SE, FWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALBODY ELECTRICALCHASSIS ELECTRICALIGNITION SWITCHIMMOBILIZER SYSTEM DIAGNOSISSYMPTOM PROCEDURESINSPECTION PROCEDURE 1: COMMUNICATION WITH SCAN TOOL MB991958 IS IMPOSSIBLETECHNICAL DESCRIPTION (COMMENT)
2007 Mitsubishi Endeavor SE, FWD
Technical Description (Comment)
2007 Mitsubishi Endeavor SE, FWDSECTION Technical Description (Comment)
- This malfunction may be caused by a defective immobilizer-ECU, PCM, or a defect in the communication line between the immobilizer-ECU and PCM. If this malfunction appears when the MFI system and scan tool MB991958 can communicate each other, MFI system DTC P0513 will reset.
- If the MFI system is normal, the MFI relay can be determined as normal. In addition, if the MFI system and scan tool MB991958 can communicate each other, the circuits between the data link connector and the PCM can determined as normal.NOTE: If this malfunction appears, MFI system DTC P0513 will be output.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.