SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2007ENDEAVOR SE, FWDREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESTRACTION CONTROLTRACTION CONTROL/ACTIVE SKID CONTROL SYSTEMTCL/ASC DIAGNOSISDIAGNOSTIC FUNCTIONHOW TO PERFORM ACTUATOR TEST
2007 Mitsubishi Endeavor SE, FWD

How To Perform Actuator Test

2007 Mitsubishi Endeavor SE, FWDSECTION How To Perform Actuator Test

Required Special Tools: 

  • MB991958: Scan Tool (M.U.T.-III Sub Assembly)
    • MB991824: Vehicle Communication Interface (V.C.I.)
    • MB991827: M.U.T.-III USB Cable
    • MB991910: M.U.T.-III Main Harness A
CAUTION: To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991958.
  1. Connect scan tool MB991958 to the data link connector.
  2. Turn the ignition switch to the "ON" position.
  3. Select "Interactive Diagnosis" from the start-up screen.
  4. Select "System Select."
  5. Choose "ABS/ASC/ASTC" from the "CHASSIS" tab.
  6. Select "MITSUBISHI."
  7. Choose "Actuator Test" from "ABS/ASC/ASTC" screen.
  8. Choose an appropriate item and select the "OK" button.
    Fig 1: Connecting Scan Tool To Data Link Connector
    G04231129Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.