Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMITSUBISHI2007ENDEAVOR SE, FWDREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESTRACTION CONTROLTRACTION CONTROL/ACTIVE SKID CONTROL SYSTEMGENERAL DESCRIPTIONACTIVE SKID CONTROL SYSTEM OPERATIONDURING NORMAL BRAKINGNOTES

2007 Mitsubishi Endeavor SE, FWD

During Normal Braking: Notes

2007 Mitsubishi Endeavor SE, FWDSECTION Notes

Fig 1: Active Skid Control System Operation - During Normal Braking

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

The brake fluid flows from the master cylinder to the cut valve and the inlet valve to supply fluid pressure to the relevant wheels.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.