Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2007ENDEAVOR SE, FWDREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESTRACTION CONTROLTRACTION CONTROL SYSTEM (TCL)TRACTION CONTROL SYSTEM (TCL) DIAGNOSISDIAGNOSTIC TROUBLE CODE PROCEDURESU1400: DYNAMIC RANGE ERROR APS1DTC SET CONDITION
2007 Mitsubishi Endeavor SE, FWD
DTC Set Condition
2007 Mitsubishi Endeavor SE, FWDSECTION DTC Set Condition
This code is set when the MFI system sets either of DTCs P2138, P2122 or P2123.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.