Enabling/Disabling The Horn Answer Back Function

2007 Mitsubishi Endeavor SE, FWDSECTION Enabling/Disabling The Horn Answer Back Function
  1. Remove the ignition key.
  2. Push the "lock" button and then push the "unlock" button after 4 seconds and 10 seconds.
  3. Release the "lock" or "unlock" button and then release the "unlock" or "lock" button within 10 seconds after Step  2. The ETACS-ECU tone alarm will sound, indicating that the horn answer back function can be enabled or disabled.
    • Enable the horn answer back function*: The ETACS-ECU tone alarm will sound once. 
    • Disable the horn answer back function: The ETACS-ECU tone alarm will sound twice. 
    • Enable the horn answer back function**: The ETACS-ECU tone alarm will sound three times. 
    NOTE: *: The horn will sound if "lock" button is pressed with the doors locked.
    **: The horn will sound if the doors are locked with the keyless entry system.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.