Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2007ENDEAVOR SE, FWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTENTERTAINMENT SYSTEMSCHASSIS ELECTRICALIGNITION SWITCHIMMOBILIZER SYSTEM DIAGNOSISSYMPTOM CHART
2007 Mitsubishi Endeavor SE, FWD
Symptom Chart
2007 Mitsubishi Endeavor SE, FWDSECTION Symptom Chart
CAUTION:
During diagnosis, a DTC associated with other system may be set when the ignition switch is turned on with connector(s) disconnected. On completion, confirm all systems for DTC (s). If DTC (s) are set, erase them all.
SYMPTOM CHART
| SYMPTOM | INSPECTION PROCEDURE NO. |
|---|---|
| Communication with scan tool MB991958 is impossible. | 1 |
| The ignition key cannot be registered. | 2 |
| Engine cranks, but does not start. | 3 |
| The immobilizer indicator light does not illuminate. | 4 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.