SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2007ENDEAVOR LS, AWDREPAIR AND DIAGNOSISSTEERINGSTEERING COLUMNPOWER STEERING GEAR BOX AND LINKAGEREMOVAL AND INSTALLATIONREMOVAL SERVICE POINTS<< A >> TIE ROD END AND KNUCKLE DISCONNECTION
2007 Mitsubishi Endeavor LS, AWD

&lt;&lt; A &gt;&gt; Tie Rod End And Knuckle Disconnection

2007 Mitsubishi Endeavor LS, AWDSECTION << A >> Tie Rod End And Knuckle Disconnection
CAUTION:
  • Do not remove the nut from ball joint. Loosen it and use special tool MB991897 to avoid possible damage to ball joint threads.
  • Hang special tool MB991897 with a cord to prevent it from falling.
  1. Install special tool MB991897 as shown in the illustration.
    Fig 1: Installing Special Ball Joint Tool
    G04231201Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Turn the bolt and knob as necessary to make the jaws of special tool MB991897 parallel, tighten the bolt by hand and confirm that the jaws are still parallel.
    NOTE: When adjusting the jaws in parallel, make sure the knob is in the position shown in the illustration.
  3. Tighten the bolt with a wrench to disconnect the tie rod end.
    Fig 2: Properly Adjusting Jaws
    G04312585Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.