Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2007ENDEAVOR LS, AWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTCRUISE CONTROL SYSTEMSAUTO-CRUISE CONTROLON-VEHICLE SERVICEAUTO-CRUISE CONTROL SWITCH CHECKAUTO-CRUISE CONTROL SETTING
2007 Mitsubishi Endeavor LS, AWD
Auto-Cruise Control Setting
2007 Mitsubishi Endeavor LS, AWDSECTION Auto-Cruise Control Setting
- Switch "ON" the "CRUISE" (MAIN) switch.
- Drive at the desired speed, above approximately 40 km/h (25 mph).
- Push the auto-cruise control switch in the direction of arrow.
- Check to be sure that when the switch is released the speed is the desired constant speed.NOTE: If the vehicles speed decreases to approximately 15 km/h (9 mph) below the set speed because of climbing a hill for example, the auto-cruise control will be cancelled.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.