Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2001MONTERO XLSREPAIR AND DIAGNOSIS (SINGLE PAGE)GENERAL INFORMATIONOBD-II DRIVE CYCLESDRIVE CYCLE PROCEDURES2011-12 OUTLANTER 3.0LPATTERN 12TEST PROCEDURE
2001 Mitsubishi Montero XLS
Test Procedure
2001 Mitsubishi Montero XLSSECTION Test Procedure
- Start the engine with all the accessories switched OFF.
- Let the engine idle for 6 minutes.
- Drive the vehicle for 30 seconds at the following conditions. (During the monitor)
- Engine speed: More than 1,200 r/m
- Engine load: More than 30%
- Throttle position sensor output: Less than 4.0 volts
- Except fuel cut
- Stop the safe place and turn the ignition switch to "LOCK" (OFF) position.
- Confirm that the diagnostic trouble code (DTC) is not output.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.