Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2001MONTERO XLSREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALCHARGING SYSTEMSGENERATORS & REGULATORSTORQUE SPECIFICATIONS
2001 Mitsubishi Montero XLS
Torque Specifications
2001 Mitsubishi Montero XLSSECTION Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | ||
|---|---|---|---|
| Generator Adjusting Bolt Lock Nut | |||
| Galant 2.4L & Mirage | 17 (23) | ||
| Generator Mounting Bolts | |||
| Diamante & Galant 3.0L | 15 (21) | ||
| Eclipse | |||
| 2.4L | 17 (23) | ||
| 3.0L | 15 (21) | ||
| Montero | |||
| M8 Bolt | 15 (21) | ||
| M10 Bolt | 38 (52) | ||
| Montero Sport 3.0L & 3.5L | 38 (52) | ||
| Generator Bracket-To-Engine Bolts | |||
| Diamante | |||
| M8 Bolt | 17 (23) | ||
| M10 Bolt | 35 (48) | ||
| Galant 3.0L | 36 (49) | ||
| Generator Pivot Bolt Nut | |||
| Diamante & Eclipse | 32 (44) | ||
| Galant & Mirage | 33 (45) | ||
| Montero Sport | 17 (23) | ||
| Generator Pulley Retaining Nut | 87 (118) | ||
| Tensioner Pulley Lock Nut | |||
| Diamante, Galant 3.0L, Montero, Montero Sport 3.0L & 3.5L | 36 (49) | ||
| INCH Lbs. (N.m) | |||
| Generator Adjusting Bolt | |||
| Galant 2.0L & Mirage | 87 (9.8) | ||
| Generator Electrical Connector Nut | |||
| Montero Sport | 124 (14) | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.