Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2001MIRAGE LS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLANTI-LOCKADJUSTMENTSWHEEL SPEED SENSORSENSOR-TO-ROTOR GAP ADJUSTMENT
2001 Mitsubishi Mirage LS, 4D Sedan, Standard
Sensor-To-Rotor Gap Adjustment
2001 Mitsubishi Mirage LS, 4D Sedan, StandardSECTION Sensor-To-Rotor Gap Adjustment
- Raise and support vehicle. Remove tire and wheel assembly. Inspect sensor pole piece for damage. Repair if necessary. If sensor pole piece is okay, check wheel speed sensor-to-rotor gap.
- Using a feeler gauge, check clearance between speed sensor pole and rotor tooth surface. See Fig 1 or Fig 2 . See WHEEL SPEED SENSOR-TO-ROTOR GAP SPECIFICATIONS table. If clearance is not within specification, loosen sensor mounting bolt. Adjust sensor position until clearance is within specification. Tighten sensor mounting bolt.
WHEEL SPEED SENSOR-TO-ROTOR GAP SPECIFICATIONS
| Application | In. (mm) | ||
|---|---|---|---|
| Front | (1) | ||
| Rear | .004-.079 (.1-2.0) | ||
|
|||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.