Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2001MIRAGE LS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)GENERAL INFORMATIONOBD-II DRIVE CYCLESDRIVE CYCLE PROCEDURES2011-12 ECLIPSE, ENDEAVOR, GALANTPATTERN 5INSPECTION CONDITIONS
2001 Mitsubishi Mirage LS, 4D Sedan, Standard
Inspection Conditions
2001 Mitsubishi Mirage LS, 4D Sedan, StandardSECTION Inspection Conditions
- Engine coolant temperature at engine start: Less than 36°C (96°F)
- Intake air temperature at engine start: Less than 36°C (96°F)
- Fuel amount at engine start: More than 15%, less than 40%
- Engine coolant temperature: More than 60°C (41°F)
- Intake air temperature: More than 5°C (41°F)
- Barometric pressure: More than 76 kPa (22.5 inHg)
- Fuel temperature: Less than 36°C (96°F)
- Condition of A/T: Selector lever "D" range
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.