Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2001MIRAGE LS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS - SELF-DIAGNOSTICSVERIFYING REPAIRSOBD-II DRIVE CYCLESHEATED OXYGEN SENSOR MONITOR
2001 Mitsubishi Mirage LS, 4D Sedan, Standard
Heated Oxygen Sensor Monitor
2001 Mitsubishi Mirage LS, 4D Sedan, StandardSECTION Heated Oxygen Sensor Monitor
This monitor applies to DTCs P0130, P0133, P0136, and P0139. Following conditions must be met during the test:
- Engine coolant temperature must be 176°F (80°C) or more.
- Atmospheric temperature is 14°F (-10°C) or more.
- On A/T, selector lever is in "D" range.
Monitor takes about 5 minutes to complete. To run monitor, use illustration. See Fig 1 . Perform steps as follows:
- Remove all test equipment from vehicle and install all components and connectors that were removed or disconnected during testing.
- After engine is completely warmed up, turn ignition off.
- Start engine and accelerate to 35-40 MPH.
- While keeping accelerator pedal position constant, keep speed at 35-40 MPH for 120 seconds or more. On M/T, use 4th gear.
- Return vehicle to shop and turn ignition off.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.