Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2001MIRAGE LS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCRUISE CONTROL SYSTEMSSYSTEM TESTSTEST NO. 4: CRUISE CONTROL DOES NOT CANCEL WHEN CLUTCH IS DEPRESSED
2001 Mitsubishi Mirage LS, 4D Sedan, Standard
Test No. 4: Cruise Control Does Not Cancel When Clutch Is Depressed
2001 Mitsubishi Mirage LS, 4D Sedan, StandardSECTION Test No. 4: Cruise Control Does Not Cancel When Clutch Is Depressed
- Check clutch pedal position switch. See CLUTCH PEDAL POSITION SWITCH (M/T) TEST under COMPONENT TESTS. Replace switch if faulty. If clutch pedal position switch is okay, go to next step.
- Disconnect clutch pedal position switch. Check voltage between ground and clutch pedal position switch harness side connector terminal No. 2 (Black/Red wire). If voltage is 4.5 volts or greater, go to next step. If voltage is less than 4.5 volts, go to step 4 .
- Check harness and junction connectors between clutch pedal position switch and ground. Repair as necessary. If connectors are okay, check circuit between clutch pedal position switch and ground. See WIRING DIAGRAMS . Repair as necessary. If circuit is okay, replace cruise control ECU.
- Check cruise control harness connector. Repair as necessary. If connector is okay, check circuit between clutch pedal position switch and cruise control ECU. Repair as necessary.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.