Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2000GALANT LS V6-3.0L SOHCREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSVEHICLE SPEED SENSORTESTING AND INSPECTION
2000 Mitsubishi Galant LS V6-3.0L SOHC
Vehicle Speed Sensor: Testing and Inspection
2000 Mitsubishi Galant LS V6-3.0L SOHCSECTION Testing and Inspection
VEHICLE SPEED SENSOR CHECK
1. Remove the vehicle speed sensor and connect a 3 - 10 K ohms resistor as shown in the illustration.
2. Turn the shaft of the vehicle speed sensor and check that there is voltage between terminals 2 - 3. (1 turn - 4 pulses)
3. If within the standard value the vehicle speed sensor is OK
If not within the standard value, replace the vehicle speed sensor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.