Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Mitsubishi Eclipse GS, AutomaticFACTORY OEM SERVICE PROCEDURE
Sensor-To-Rotor Gap Adjustment
- Raise and support vehicle. Remove tire and wheel assembly. Inspect sensor pole piece for damage. Repair if necessary. If sensor pole piece is okay, check wheel speed sensor-to-rotor gap.
- Using a feeler gauge, check clearance between speed sensor pole and rotor tooth surface. See Fig 1 or Fig 2 . See WHEEL SPEED SENSOR-TO-ROTOR GAP SPECIFICATIONS table. If clearance is not within specification, loosen sensor mounting bolt. Adjust sensor position until clearance is within specification. Tighten sensor mounting bolt.
WHEEL SPEED SENSOR-TO-ROTOR GAP SPECIFICATIONS
| Application | In. (mm) |
|---|---|
| Front & Rear | 1.11-1.12 (28.2-28.5) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.