Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI1995MONTERO LS, AUTOMATIC, V4AW3REPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSCOMMON SPECS & PROCEDURESSPECIFICATIONS INDEX
1995 Mitsubishi Montero LS, Automatic, V4AW3
Specifications Index
1995 Mitsubishi Montero LS, Automatic, V4AW3SECTION Specifications Index
MONTERO SPECIFICATIONS INDEX
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | A/C SYSTEM GENERAL SERVICING | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Axle Shaft/Bearing Lock Nut/Drive Axle Nut (Front) | TORQUE SPECIFICATIONS | ||
| Battery | |||
| 3.0L | CAPACITIES | ||
| 3.5L | CAPACITIES | ||
| Brakes | |||
| Bleeding Sequence | BLEEDING BRAKE SYSTEM | ||
| Disc Brakes | DISC BRAKE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Drum Brakes | N/A | ||
| Torque | N/A | ||
| Charging | |||
| Generator | |||
| 3.0L | ON-VEHICLE TESTING | ||
| 3.5L | ON-VEHICLE TESTING | ||
| Torque | N/A | ||
| Drive Belts | |||
| Adjustment | BELT ADJUSTMENT | ||
| Belt Routing | BELT ROUTING | ||
| Engine Cooling | |||
| General Service Specifications | COOLING SYSTEM SPECIFICATIONS | ||
| Radiator Cap Pressure | 11-15 psi | ||
| Thermostat R & I | |||
| 3.0L | THERMOSTAT | ||
| 3.5L | THERMOSTAT | ||
| Water Pump R & I | |||
| 3.0L | WATER PUMP | ||
| 3.5L | WATER PUMP | ||
| Engine Mechanical | |||
| 3.0L | |||
| Compression | ENGINE COMPRESSION | ||
| Oil Pressure | Oil pressure should be at least 11 psi (.8 kg/cm2 ) at idle and engine oil temperature of 167-194°F (75-90°C). | ||
| Overhaul | GENERAL ENGINE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| 3.5L | |||
| Compression | ENGINE COMPRESSION | ||
| Oil Pressure | Oil pressure should be at least 11 psi (.8 kg/cm2 ) at idle and engine oil temperature of 167-194°F (75-90°C). | ||
| Overhaul | ENGINE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE/FLUIDS tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flex Plate (Drive Plate) Torque | 53-55 Ft. Lbs. (72-75 N.m) | ||
| Fuel System | |||
| 3.0L | |||
| Pressure Specification | FUEL PUMP | ||
| Fuel Pressure Test Procedure | FUEL PRESSURE | ||
| Fuel Filter | FUEL FILTER | ||
| 3.5L | |||
| Pressure Specification | FUEL PUMP | ||
| Fuel Pressure Test Procedure | FUEL PRESSURE | ||
| Fuel Filter | FUEL PUMP | ||
| Ignition | |||
| 3.0L | |||
| Firing Order & Cylinder Identification | FIRING ORDER | ||
| Ignition Wires (Resistance) | HIGH TENSION WIRE RESISTANCE | ||
| Ignition Wires (Routing) | FIRING ORDER | ||
| 3.5L | |||
| Firing Order & Cylinder Identification | FIRING ORDER | ||
| Ignition Wires (Resistance) | HIGH TENSION WIRE RESISTANCE | ||
| Ignition Wires (Routing) | FIRING ORDER | ||
| Spark Plug | |||
| 3.0L | SPARK PLUGS | ||
| 3.5L | SPARK PLUGS | ||
| Starting | STARTER SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 72-87 Ft. Lbs. (98-118 N.m) | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.