Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI1995MONTERO LS, AUTOMATIC, V4AW3REPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALCOMPONENT LOCATIONSELECTRICAL COMPONENT LOCATORCONTROL UNITS
1995 Mitsubishi Montero LS, Automatic, V4AW3
Control Units
1995 Mitsubishi Montero LS, Automatic, V4AW3SECTION Control Units
CONTROL UNITS
| Component | Component Location |
|---|---|
| ABS Control Unit | Mounted on top of right rear wheelwell, under metal plate. |
| A/C Control Unit | On top of evaporator case. See Figure . |
| Cruise Control Unit | Behind center console. |
| Door Lock Control Unit | Behind left side of dash. |
| ELC 4-Speed A/T Control Module | Behind left side of dash. |
| Engine Control Module (ECM) | Behind right kick panel. See Figure . |
| Keyless Entry Control Unit | Behind right side quarter panel. |
| Motor Antenna Control Unit | Behind center console. |
| Rear Differential Lock Control Unit | Mounted on top of rear right wheelwell, under metal plate. |
| SRS Diagnostic Unit | Behind center console. |
| Sunroof Control Unit | On center of roof, behind sunroof. |
| Variable Shock Absorber Control Unit | Behind left rear wheelwell, behind quarter panel. |
| 4WD Indicator Control Unit | Behind center of dash. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.