Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI1995MONTERO LS, AUTOMATIC, V4AW3REPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEPOWER WINDOWSCOMPONENT TESTINGPOWER WINDOW RELAY
1995 Mitsubishi Montero LS, Automatic, V4AW3
Power Window Relay
1995 Mitsubishi Montero LS, Automatic, V4AW3SECTION Power Window Relay
- Remove power window relay from fuse/relay block located in engine compartment. SeeFig 1 . Check continuity between power window relay terminals No. 2 and 4. Continuity should be present.
- Connect positive lead of a 12-volt battery to power window relay terminal No. 2, and negative lead of battery to terminal No. 4. SeeFig 2 . Continuity should be present between terminals No. 1 and 3 with voltage applied. Replace power window relay if continuity is not as specified.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.